Toecurler
Longboard · 9'0 to 10'3
A proper longboard built for trim, glide and time on the nose. An all-round shape that noserides well, without being so specialised it falls apart everywhere else.
- Family
- Longboard
- Size range
- 9'0 to 10'3
- Fin set-up
- Single fin. An all-rounder, flex or pivot fin can be used depending on preference.
- Construction
- PU, EPS or agave blank, glassed with high bio-content epoxy resin.
Outline
Wide, parallel rails through the mid-section with a full round nose, available with a square, round or pin tail. Width through the nose is intentional, creating the lift needed to walk forward and hang toes without the nose going under.
Rocker
Flat to minimal throughout. Low entry rocker feeds into a flat middle section for maximum glide and trim speed. The tail has just enough curve to allow the board to pivot when needed without interrupting the flow.
Bottom contours
Deep concave through the nose creates suction and lift when weight moves forward, which is what makes noseriding possible. Through the mid-section, the board transitions to belly, helping it sit on top of the water and glide. Vee through the tail adds pivot and looseness, making the board easier to turn for its length.
Rails and tail
Wide, parallel rails through the mid-section with a full round nose and square, round or pin tail options.
Good for
Noseriding, trimming, cross-stepping, small to medium surf, and surfers who want to slow things down and focus on style and connection with the wave.
Approved options
- Pin tail
- Round tail
- Square tail
- Reclaimed wooden tail block
- Custom finish
- Single fin set-up
Custom build
Start a custom board using the Toecurler.
Shape range